S CLASS™ 2 cutter User’s Manual
Detailed Operation 4-11
Autoload:
The Autoload option enables the user to the change the unroll-procedure of the vinyl. When
autoload is on, the cutter will automatically unroll the vinyl, when needed. When the autoload
option is set off, the operator should manually unroll enough media before starting to cut.
When autoload is set to ask, then the cutter will pause after the pinch rollers are put down.
This gives the user the time to lower the pinch roller pressure, if necessary.
The default setting is ON. Tracking is not guaranteed when autoload is set to OFF.
Press the Autoload button, then choose to activate or deactivate the autoload feature.
Press to confirm or to cancel. Autoload is activated default.
Language:
This submenu is used to set or modify the dialogue language on the touch screen. When the
machine is new, it asks the user to choose a language. If this setting was set to the wrong
language, it can be changed with this option.
The information on the touch screen can be displayed in English, French, German, Spanish,
Italian, Polish, Dutch or Lithhaunian.
Press the Language button, and then set it to the desired language.
Press to confirm or to cancel. The default language is chosen when the cutter is
switched on for the first time.
Menu Units:
The setting of these options determines whether the speed and size values are displayed in
the metric measure system or ENG/US measure system.
Press the Menu units button, then set it to the desired measure system.
Press to confirm or to cancel. panel units are chosen when the cutter is switched
on for the first time.
LCD contrast:
The LCD contrast submenu is used to adjust the contrast (or intensity) of the touch screen.
The firmware automatically rejects values that would make the touch screen too dark to be
able to use it.
Press the LCD contrast button and set it to the desired value.
Press to confirm or to cancel.
NOTE: Tracking is not guaranteed when autoload is set to OFF.
To Next Page