Summa S2 SERIES - Changing the Tool Pressure; Changing the Drag Knife Offset

S CLASS™ 2 cutter User’s Manual
Basic Operation 2-8
2.2.2 Changing the tool pressure
1. Power on the cutter and load the media.
2.
Press on pressure
3.
Press arrow up or down to
change the value.
4.
Or fill in the new value
after pressing Numpad.
1. Press to perform the internal knife pressure test.
2. Press to confirm the chosen knife pressure and exit the menu.
3. Press to leave the pressure unchanged.
2.2.3 Changing the drag knife offset
A very important parameter for a drag knife is the offset. The offset is the distance between
the knife center and the knife tip.
NOTE:
The knife offset should be set each time the knife is changed and should be
checked if the knife shows signs of wear.
NOTE:
A typical knife offset for Summa knives is between 0.41 and 0.45 for
standard knives, between 0.9 and 0.97 for sandblast knives and between 0.49 and
0.52 for the 60 degree knife.
Changing the knife offset:
1. Power on the cutter, load the media and mount the drag knife (see section 1.7.1.1 or
1.7.2.4)
2.
Press on Settings
3.
Press on Knife offset.
4.
Use arrows
to change
knife offset.
Knife pressure 95 gr
Velocity 800 mm/s
Tool Tangential knife
Media size 50000 x 718 mm
Actions
Settings
Configuration 1
Pause
Origin
Eth. 192.168.1.7
Old value: 85gr
New value: 95gr
Range: 0 ... 600gr
IP:192.168.1.7
Cancel
Apply
Test
Apply
9▌
Eth. 192.168.1.7
Cancel
Test
Apply
Cancel
Knife pressure 95 gr
Velocity 800 mm/s
Tool Tangential knife
Media size 50000 x 718 mm
Actions
Settings
Configuration 1
Pause
Origin
USB port 1
Settings
Back
More
Home
Tool
Drag knife
Velocity
800 mm/s
Knife pressure
95 gr
FlexCut
...
Advanced cutting
...
Knife offset
0.45 mm
Old value: 0.45 mm
New value: 0.43 mm
Range: 0.00 ... 1.00 mm
Settings
Cancel
Apply
Test
Old value: 0.45 mm
New value: 0.43 mm
Range: 0.00 ... 1.00 mm
Cancel
Test
Apply