Summa S 75 - Setup

Table of contents I
Table of Contents
1 Setup ......................................................................................................1-1
1.1 Unpacking the Cutter ..................................................................................1-1
1.1.1 Removing the packaging from the cutter ..................................................1-1
1.1.2 Setting up the stand ...................................................................................1-2
1.1.3 Mounting the cutter on the stand...............................................................1-4
1.2 S CLASS™ Cutter Components.................................................................1-5
1.2.1 The Cutter as viewed from the front..........................................................1-5
1.2.2 The Cutter as viewed from the back..........................................................1-7
1.3 Connecting the Cutter to the Mains...........................................................1-9
1.3.1 Grounding (“Earthing”) ...............................................................................1-9
1.3.2 Operating voltage.......................................................................................1-9
1.3.3 Powering-on the cutter.............................................................................1-10
1.4 Connecting the Cutter to a Computer .....................................................1-11
1.4.1 USB connection........................................................................................1-11
1.4.1.1 Connecting the S CLASS™ cutter to a PC using a USB cable......1-11
1.4.1.2 Connecting the S CLASS™ cutter to a Mac using a USB cable....1-12
1.4.2 RS-232 Connection..................................................................................1-13
1.5 Loading Media ...........................................................................................1-14
1.5.1 Pinch roller positioning.............................................................................1-14
1.5.2 Pinch roller pressure setting ....................................................................1-15
1.5.3 Loading media..........................................................................................1-16
1.5.4 Media load procedure ..............................................................................1-19
1.6 Tool Installation.........................................................................................1-23
1.6.1 Cutters with drag head.............................................................................1-23
1.6.1.1 Knife installation ................................................................................1-23
1.6.1.2 Pen installation..................................................................................1-27
1.6.1.3 Pouncing pin installation...................................................................1-27
1.6.2 Cutters with tangential head ....................................................................1-28
1.6.2.1 Tangential knife installation ..............................................................1-28
1.6.2.2 Pen installation..................................................................................1-32
1.6.2.3 Pouncing pin installation...................................................................1-32
1.6.2.4 Drag knife installation........................................................................1-33
1.6.3 Replacement of the separation knife blade.............................................1-33