Summa S ONE - Detailed Operation; Knife;Pen* Pressure; Knife;Pen* Offset; Main Menu

Detailed operation 4-1
4 DETAILED OPERATION
This chapter includes a detailed list of all parameters that can be changed and tests that can
be initiated from the touchscreen. Chapters 1 and 2 of this manual describe in detail the main
use of the touchscreen. This chapter can be used as a reference for locating a particular
parameter setting or test. This section also explains the less frequently used parameters.
Tap to access the main menu.
The main menu contains parameter settings and submenus. The entire menu cannot be
displayed on the screen at once, use the up and down arrows on the right to navigate through
the menu.
FIG 4-1
4-1 MAIN MENU
*Depending on what tool is installed.
This parameter is explained in section 2.2.2.
*Depending on what tool is installed.
This parameter is explained in section 2.2.3.
Knife pressure
Knife offset
FlexCut
Tool
Actions
Settings
Menu
Calibrations
Configuration
4.1 Introduction
4.2 Main menu
4.2.1 Knife/Pen* pressure
4.2.2 Knife/Pen* offset