Summa S ONE - Page 68

To Next Page

To Previous Page

S One User’s Manual

OPOS 3-16

The cutter will make a circular movement while it measures the reflection of the mark colour.

Then a value is shown that is typical for this combination of media colour - mark colour. Save

this value for future use.

NOTE: An error message may appear if the sensor is not able to differentiate

between black and white. Make sure that the test has been performed correctly.

Set value:

If a combination of media colour – mark colour has already been calibrated and set, this value

can be entered directly. Follow the procedure on the previous page up to and including step

4, then continue with the steps below.

5. Tap

Set

6. Use the arrows to change the

value or enter a value.

7. Tap to confirm.

Default value:

Follow the procedure on the previous page up to and including step 4, then perform the

following action:

5. Tap

Reset to default

Measure

Set

Reset default

Calibrate media (OPOS)

OPOS sensor level

1 2 3 0

4 5 6

7 8 9 C