Summa S ONE - Wi-Fi; Firmware; Environmental; Power Consumption

S One User’s Manual
Specifications 6-7
Wi-Fi is only available in select countries.
This is due to EMC tests done according to European Directive (2014/53/EU):
• EN 303 446-1 Ver. 1.2.1
• EN 301 489-1 Ver. 2.1.1
• EN 301 489-17 Ver 3.1.1
• EN 55032:2015 + AC:2016-07
• EN 55035:2017 + AC:2019-11
And EMC tests were done according to USA & CANADA standards:
• FCC Part 15B / ICES-003 issue 6
Following is a detailed list of countries covered by these tests and thus can have WIFI enabled:
Austria, Belgium, Bulgaria, Croatia, Cyprus, Czechia, Denmark, Estonia, Faroe Islands, Finland,
France, Georgia, Germany, Greece, Greenland, Guernsey, Holy See, Hungary, Iceland, Ireland,
Isle of Man, Italy, Jersey, Latvia, Liechtenstein, Lithuania, Luxembourg, Macedonia, The Former
Yugoslav Republic, Malta, Montenegro, Netherlands, Norway, Poland, Portugal, Romania, San
Marino, Slovakia, Slovenia, Spain, Sweden, Switzerland, United Kingdom of Great Britain,
Northern Ireland, Monaco, Turkey.
Language
DM/PL, HP-GL (758x emulation), HP-GL/2
Supported character sets
Standard ASCII
Supported fonts
Sans serif (single stroke & medium)
(Cutter without media)
Operating Temperature
15 to 35°C
59 to 95°F
Storage Temperature
-30 to 70°C
-22 to 158°F
Relative Humidity
35 – 75%, non-condensing
Number of power cords
1
Input voltage
100-240 VAC + 10%
Input frequency
50/60 Hz
Maximum load per power cord
2A
Power consumption during operation
0.25 A (@ 240V)
(*)
0.6 A (@ 100V)
(*)
Power consumption idle
0.1 A (@ 240V)
0.25 A (@ 100V)
*
Typical values, may vary depending on cutting job and material
6.2.6 Wi-Fi
6.2.7 Firmware
6.2.8 Environmental
6.2.9 Power consumption