Summa S ONE - Changing the Fuse

S One User’s Manual
Maintenance 5-4
WARNING: Before changing the fuses, make sure that the cutter is completely
disconnected from its power source.
WARNING: For continued protection against fire hazard, only replace with fuses
of the same type and rating: T2A H250V.
1. To remove the fuses, slightly pry loose the release clamps of the fuse holder. The fuse
holder pops out.
FIG 5-4
5-4 POWER ENTRY MODULE
2. Remove the fuse holder.
3. Pull the fuses out of the holder.
4. Place the new fuses in the holder and click the holder back into place.
5.1.4 Changing the fuse