SummaSign Service Manual
5.4. LOW LINE VOLTAGE...........................................................................................5.3
5.5. HIGH LINE VOLTAGE..........................................................................................5.4
5.6. ILLEGAL PLOT COMMAND.................................................................................5.4
5.7. ILLEGAL CLIP & SCALE SETTINGS..................................................................5.4
5.8. SYNTAX ERROR..................................................................................................5.5
5.9. NVRAM FAILURES AND MESSAGES.................................................................5.5
5.10. RS232 ERROR....................................................................................................5.6
5.11. INTERNAL ERRORS..........................................................................................5.6
5.12. FLASHING ERRORS AND MESSAGES (ONLY ON NEW TYPE OF PCB)......5.7
5.13. ROM ERROR......................................................................................................5.7
5.14. RAM ERROR.......................................................................................................5.7
5.15. MACHINE UNABLE TO FIND THE KNIFE HOME POSITION...........................5.8
5.16. MARKERS NOT SENSED PROPERLY.............................................................5.8
SECTION 6 FIGURES
LEFT SIDE...................................................................................................................6-2
RIGHT SIDE (1)............................................................................................................6-3
KEYBOARD ASSY......................................................................................................6-4
RIGHT SIDE (2)............................................................................................................6-5
CUTTER CARRIAGE...................................................................................................6-6
TOC-vi Table of Contents
To Next Page
Loading...
