85
- - End
10.7.3 Operation Parameters
It is recommended that the input voltage of the DC battery of two PCS units sharing
a transformer in the MV system be controlled within 100V, and excessive voltage
difference will affect the performance of the parallel system.
It is recommended that the power dispatching mode of two PCS units sharing a
transformer in the MV system should be consistent, the charge and discharge
modes should be consistent, and the active mode or reactive mode should be con-
sistent. Mixing of charging and discharging, active and reactive power is
prohibited.
step 1 Click “[Device Monitoring]” to enter the corresponding interface.
step 2 Click “[Operation Parameters]” to view the running parameters of the device.
- - End
10.7.4 Protection Parameters
step 1 Click “[Device Monitoring]” to enter the corresponding interface.
step 2 Click “[Protection Parameters]” to view the protection parameters of the device.
- - End
10.7.5 System Parameters
step 1 Click “[Device Monitoring]” to enter the corresponding interface.
step 2 Click “[System Parameters]” to view the system parameters of the device.
- - End
10.7.6 Timed Charge and Discharge
Before entering the [Timed Charge and Discharge] interface, enable the switch “[Timed
Charge and Discharge]” on the operation parameters interface.
10.7.6.1 Enter
step 1 Click “[Device Monitoring]” to enter the corresponding interface.
step 2 Click “[Timed Charge and Discharge]” to set Start Time, End Time, and Power of the timer.
- - End
10.7.6.2 Setting steps
step 1 Select a device, and click “[Add]” to add a time and power setting field.
User Manual 10 Web Operation
To Next Page
Loading...
Need help?
General
