50
1) Names of Each Part in the Simple Operation Unit
2) Simple Program Unit Method of Use
(1) Initializing
SIMPLE OPERATION UNIT PART NAMES AND METHOD OF USE
99
※ Simple operation unit is attached in the front of the control box and used when there is no program unit panel.
4-Digit Displayer
Start B/T Programming Displayer
A Button Switch
End B/T Programming Displayer
B Button Switch
Thread Trimming and Wiper Programming Displayer
Button Switch for Program Changes
Presser Foot-lift Up Stop and Down Stop Programming Displayer
D Button Switch
Needle Plate Up Stop and Down Stop Programming Displayer
C Button Switch
This function is used when the user randomly corrects the programmed value and forgets the initial programmed value.
Turn the power on by simultaneously pressing the buttons , and , .
Caution
•When you initialize, you change all the original values that the sewing machine had when it was manufactured in the factory.
Initialize only when absolutely necessary.
•When initializing, you must run the motor for more than 5 seconds at the speed of 1000RPM in order to make the synchronizer
to work properly.
To Next Page
Loading...
Need help?
General
