55
1) Basic Functions of the Fortuna Series 5 Full Function Software
(1) Initializing
(2) Sewing Machine Up/Down Stop Location Automatic Recalling Function
When first purchasing the controller, if the user steps on the pedal for 5 seconds and runs the motor before beginning the sewing work, the
machine will automatically remember the sewing machine's up/down stop location. However, when using a synchronizer this step is not
necessary.
(3) Method of Use and Functions of the Program Unit and the General Control Box's Simple Operation Box.
When there is a program unit(P/U), use it to program or change all the functions of the machine. When there is no program unit, use the
general control box operation panel to program or change all the functions of the machine.
※ For detailed information on the method of use of program units and simple operation panel refer to the explanation in the last section.
(4) Function Parameter
FORTUNA SERIES 5 FULL FUNCTION SOFTWARE METHOD OF USE
1100
This function is used when the user randomly changes the parameter's programmed value, and forgets the original program contents.
Method of initializing: Turn the power on by simultaneously pressing the buttons in the figure above which are the start B/T button + end B/T
button + needle plate up/down stop button.
Caution
•If you initialize, all the changes made by the user are changed to the original values programmed when the
machine was delivered from the factory, therefore only change the value if absolutely necessary.
•After initializing, rotate the machine for 1000RPM or more for approximately 5 seconds. You must make the
machine remember the location of the FILM.
Parameter group Functions
① Group A General functions of the sewing machine
② Group B All types of output, Full-on Time/PWM Duty, checking input/output operations, sewing machine models and
thread trimming sequence programming
③ Group C Pedal acceleration/deceleration curve, slow starting speed and input/output port change related parameters
④ Group D All types of gain parameter related motor control
⑤ Group E Automatic Change Function of Twin Needles
Related Parameters
※ If the specific items of the parameter are changed carelessly, they could cause breakdown or damage the machine. Therefore the
user must be well-trained before using it.
To Next Page
Loading...
Need help?
General
