133
You can send data other than the basic patterns to the rest of the pattern
number area to receive pattern data from your PC. Here, SPS-1254 is used
as an example to demonstrate the transmission process. The pattern number
for initial transmission will be “r-57”.
At this point, click “Port Checking”
in the serial communication
dialog to see the communication
connection between the bartack
machine and SSP. If they are
connected, you will see a
“successfully connected” message.
2. Press Ready.
The pattern number for transmission
will pop up.
In bar tack series, the
initial pattern number for
transmission
will differ by type for basic
patterns used all vary by type.
The following shows basic
patterns used for different types.
1. SPS-1201 Series: 1~32
2. SPS-1202 Series: 1~33
3. SPS-1254 Series: 1~56
3. Use + and - key to select the
pattern number you wish to
receive.
You can receive anywhere from
57 to 99.
(SPS-1254)
To Next Page
Loading...
