156
⑤ Now the data is normally saved in the buffer.
You have only to save record the program buffer
saving data to the ROM. Click “Write ROM”
among the function buttons. The screen stops for
dozens of seconds, and the following message is
displayed. (Although there is no reaction, it is not
wrong because the data is being recorded.)
⑥ Data is completely recorded in the ROM through
above Item ⑤. Finally, check if the data has been
normally recorded in the ROM.
That is, this reads the data saved to the ROM to
display it to the screen. Click “Read”in the menu.
At this time it reads data for a few seconds without
reaction, and a message is displayed for normal
reading. Otherwise an error message is
displayed. Then, you have only to display the data
saved to the buffer through “Edit Buffer”in above
Item ④. If all data includes values such as
“00 00 00...”or “FF FF FF...”, this means that
data is not normally saved to the ROM.
If there is no display in spite that data is displayed in the screen through
“Edit Buffer”after reading, press the keyboard’s up-and-down direction
keys.
Note
To Next Page
Loading...
