46
① This creates stitches with the same method as
“Normal Stitching”, except clicking“Zigzag
Stitching” instead of “Normal Stitching”
② Upon clicking “Zigzag Stitching”, “zigzag Stitch
Dialog”id displayed.
③ As shown in the figure, you can find a little more
complicated input boxes than Normal Stitch:
Width to determine the width of sewing data, and
Stitch Length (pitch) identical with Nominal Stitch.
The followings show buttons to set up start
direction upon creating zigzag stitches. And there
is a Speed Input box (not be currently provided).
The third is a speed-related input box;
however, this box is not applied yet. In the next
item, Zigzag types are presented.
As can be seen in the picture, there are 4
Zigzag types.
·Left to the center
·Right to the center
·Upper right to the center
·Lower left to the center
Each item contains the Zigzag staring direction
and creation location. You can select one from
the 4 types.
④ Click “OK”, you can find that zigzag sewing data is
created as follows:
··
ZigZag Stitching
The following zigzag sewing data is provided to help you understand each parameter.
ZigZag Length(pitch)
ZigZag Width
Right
Left
To Next Page
Loading...
