48
⑥ The following figure shows that Second Origin is
created. “2-Origin”in red is displayed at its crea-
ting place.
① Sewing data should be created before creating a
thread trimming command. (Please refer to
“Creating Sewing Data”.)
② Click Trim at Machine Tool Bar, then the sel-
ected button gets concaved.
③ Place Mouse Point where Sewing Data is created,
click the mouse’s left button. Then the bold part is
the enlarged part as shown in the figure.
And blue dots indicate selected joints.
④ Click the mouse’s right button to display Thread
Trim Command Dialog as shown in the figure.
Click “OK”to input a thread trimming command,
otherwise click “Cancel”.
⑤ The following shows a figure including the thread
trimming commands, which are displayed a “Trim”
in blue.
Please refer to the Mechanical Manual for the details of Second Origin.
··
Thread Timming Command
To Next Page
Loading...
