56
This function enables the setting of the system delay time at a chosen needle data
position upon punching. When the time delay code appears in the middle of sewing,
the sewing is suspended for the delay time whose setting was made previously, and
resumes after the set time. To set time delay, use the I/O port input code together to
set the optimized motion.
Follow the steps below to use the function.
① Assume that there is a square pattern design as below. When time delay is set at Point
A of the square, the sewing machine will stop operation at Point A and resume
operation after the set delay time passes.
··
Delay Time Control Command
② Select the time delay function button. When selected, the button
remains pressed. Select the stitch point located at the desired
position for input as Point A. The selected stitch point turns red.
To Next Page
Loading...
