55
③ Press the right mouse button. When the button is
pressed, the output port setting dialogue window
appears at the same time. Select the output port
signal for setting.
Input port setting : User can set input port.
LOW : Input signal is low.
HIGH : Input signal is high.
Set HIGH for input port 4.3.
④ The figure below shows the design when the input port is set.
The input port table above is applicable when the C-SERIES I/O
board is used. In the existing A/B-SERIES, OP4.0~OP4.7 cannot be
used. In the C-SERIES, IP 4.2 cannot be used.
143-HI
To Next Page
Loading...
