58
This function can program the head connected to a selected output port to move up
or down upon punching. In other words, when a signal is produced from the selected
output port in the middle of sewing, the head will move up or down. Therefore, if you
are not a trained and skilled engineer, take extra care in using the function.
Follow the steps below to use the function.
① Assume that there is a square pattern design as below. This is an exercise aimed to
operate the head-up and head-down at Point A and Point B of the square.
··
Head Up/Down Control Command (for C-Series only)
B
② Select the Head Up/Down function button. When selected, it
remains pressed. Select the stitch point located at the desired
position for move-up/move-down as Point A. The selected stitch
point turns red.
A
To Next Page
Loading...
