96
··
Mirror
⑤ Click “OK”, then you can find that
the same pattern is creted based
on Y-axis marker.
Mirror the selected configuration and sewing data.
① Select the configuration and sewing data to mirror.
② Select Mirror to display Mirror Reflection Dialog.
It includes the following functions:
X axis : Mirror based on X-axis.
Y axis : Mirror based on Y-axis
Point : Set up any position of a user, and mirror
it. This figure shows Mirror based on Y-axis.
③ Click “OK”. The selected pattern is displayed to
the whole range with dotted lines as shown in
the figure.
④ Immediately click the mouse’s right button,
Mirror Point Dialog is displayed.
To Next Page
Loading...
