Supero SMT IPMI User Manual

SMT IPMI User's Guide
B-6
•set
Use the command verb set to assign a set of values to the properties of a target
machine.
•start
The command verb start is used to turn on the power control, to start a process, or
to change an operation state from a lower level to a higher level in a system.
•stop
The command verb stop is used to turn off the power, to stop a process, or to
change an operation state from a higher level to a lower level.
•reset
The command verb reset is used to enable or to disable the power control of or
the processes of the machine.
•delete
The command verb delete is used to delete or to destroy an entry or a value previ-
ously entered. It can only be used in a specic target as dened according to the
SAMSHCLP Standards.
•load
The command verb load is used to move a binary image le from a URI source to
the MAP. This command will achieve different results depending on the setting of
a target system, and how the verb load is dened in the DSP specication used
in the system.
•dump
The command verb dump is used to move a binary image le from the MAP to a
URI source. This command will achieve different results depending on the setting
of a target system, and how the verb dump is dened in the DSP specication
implemented in the system.
•create
The command verb create is used to create a new address entry or a new item in
the MAP. It can only be used in a specic target as dened in the SMASH prole
or in MAP specications.

Supero SMT IPMI Specifications

General

Brand	Supero
Model	SMT IPMI
Category	Controller
Language	English