SMT IPMI User's Guide
B-4
B-5 SMASH-CLP Main Screen
After you've successfully logged in the SSL network, the SMASH Command Line
Protocol Main screen will display as shown below.
B-6 Using SMASH for System Management
After you've familiarized yourself with SMASH commands, you are able to use these
commands to manage your system. To properly manage your network system, be
sure to follow the instructions below.
Note:
Make sure that the format of all your commands are compliant with the
DMTF
specication, which
is
"<V
erb>
[<option>] [<target>]
[<properties>]",
where:
•A Verb means a command.
•An Option works according to the denition of a command given in Section
7: Denitions of Command Verbs.
•A Target is a managed device which is also referred to in the diagram of
Target Addressing as shown in Figure 2.1.
•Properties are the specic attributes that you want to assign to a target
machine or to get from a target machine.
Figure 2 SMASH-CLP Main Screen
To Next Page
Loading...
Need help?
General