IntelliShot & FlexoShot: Operations Manual Page 6
POWER REQUIREMENTS
SureShot dairy dispensers require a power source receptacle with specifications as indicated on the
product identification label. For more information, please refer to the Introduction in this manual.
The power cord has a 3-prong attachment plug. This plug is designed to fit a receptacle with provisions
for a grounding stud. The dispenser must be operated on grounded electrical wiring at all times. Failure
to do so will void the warranty.
If the power supply cord is damaged, it must be replaced with an approved cord or assembly available
from the manufacturer or its service agent.
TOOLS FOR SETUP AND MAINTENANCE
• Medium Philips (2P) screwdriver
• Large Philips (3P) screwdriver
• Spirit Level
CLEANING THE DISPENSER
Before using the dispenser for the first time, it must be thoroughly cleaned. The dispenser must be
cleaned regularly for optimal performance. Follow the instructions in the Cleaning the Dispenser
section of this manual.
INSTALLING AN ATTACHABLE CATCH TRAY
Not all dairy dispensers include an attachable catch tray.
1. Align the two keyholes of the catch tray with the screw heads located on the bottom of the
front panel.
2. Gently pull the catch tray down to secure it in place.
CHANGING DOOR GRAPHIC (OPTIONAL ILLUMINATED DOOR DISPLAY)
1. Unhook the door latch and open the dispenser door.
Figure 5: Illuminated door display
Actual door graphic may not be exactly as shown.
To Next Page
Loading...
Need help?
General
