Suzuki DR650SE User Manual

5·13 CHASSIS
MASTER CYLINDER REASSEMBLY AND
REMOUNTING
Reassemble the master cylinder in the reverse order of
removal and disassembly. Pay attention to the following
points:
! ACAUTION!
* Wash the master cylinder components with fresh
brake fluid before reassembly. Never use cleaning sol-
vent or gasoline to wash them.
* Do not wipe the components with a rag.
* Apply brake fluid to the cylinder bore and all the com-
ponent to be inserted into the bore.
~ Specification and classification: DOT 4
• When remounting the master cylinder on the handlebars,
align
the master cylinder holder's lower mating surface
CD with punched mark 0 on the handlebars and tighten
the upper clamp bolt first as shown.
~ Master cylinder mounting bolt:
10 N·m (1.0 kg-m, 7.0 Ib-ft)
! ACAUTION!
Bleed air from the system after reassembling master
cylinder. (Refer to page 2-11.)
Upper
clamp
bolt
"UP" mark
--H-
Clearance

Suzuki DR650SE Specifications

General

Bore x Stroke	100.0 mm x 82.0 mm
Compression Ratio	9.5:1
Fuel System	Mikuni BST40 carburetor
Ignition	Electronic ignition (CDI)
Transmission	5-speed constant mesh
Final Drive	Chain
Front Suspension	Telescopic, coil spring, oil damped
Front Tire	90/90-21
Rear Tire	120/90-17
Curb Weight	166 kg (366 lbs)
Starter	Electric
Engine Type	4-stroke, air-cooled, SOHC
Front Brakes	Disc brake
Rear Brakes	Disc brake
Fuel Tank Capacity	13.0 L (3.4 US gal.)
Overall Width	865 mm (34.1 in)
Ground Clearance	265 mm (10.4 in)
Seat Height	885 mm (34.8 in.)
Rear Suspension	Link type, coil spring, oil damped