Suzuki DR650SE - Starter Clutch and Generator

3-51 ENGINE
STARTER CLUTCH AND GENERATOR
• Install the crankcase oil separator and spacer CD.
• Tighten the ring nut to the specified torque with the spe-
cial
tools .
• MOl. 09917-23711: Ring nut socket wrench
09910-2011 6: Conrod holder
~ Ring nut: 80 N'm (8_0 kg-m, 58.0 Ib-ft)
• Install the starter gear and thrust washer.
• Degrease the tapered portion of the generator rotor and
also
the crankshaft.
• Fil the key @ in the key slot on the crankshaft, then in-
stall
the generator rotor.
• Apply a small quantity of THREAD LOCK SUPER" 1303"
to the threaded part of rotor bolt.
~ 99000-32030: THEAD LOCK SUPER "1303"