Suzuki DR650SE - Carburetor Cleaning Procedure

4·11 FUEL AND LUBRICATION SYSTEM
• Remove the float assembly G) and needle valve 0.
! ACAUTION!
Do not use a wire for cleaning the valve seat.
• Remove the main jet @, pilot jet @ and pilot screw @
(Refer to PILOT SCREW REMOVAL of page 4-12 for E-03,
18 and 33 models).
! ACAUTION!
Do not use a wire for cleaning of passage and jets.
NOTE:
Before removing the pilot screw @, slowly turn the pilot
screw in clockwise and count the number of turns until the
screw is lightly seated. Make a note of how many turns were
made so the screw can be reset correctly after removing.
• Remove the main air jet @.
! ACAUTION!
I Do not use a wire for cleaning of jet.
CARBURETOR CLEANING
AWARNING
Some carburetor cleaning chemicals, especially dip-type
soaking
solutions, are very corrosive and must be han-
dled
carefully. Always follow the chemical manufac-
turer's instructions on proper use, handling and strage.
NOTE:
Remove the pilot screw as described next page before
cleaning.