Suzuki GSX1300BK B-King - Page 306

Engine Mechanical: 1D-70
3) Make sure that all of the bolts are removed. Then,
tap the sides of the lower crankcase using a plastic
hammer to separate the upper and lower crankcase
halves and then lift the lower crankcase off of the
upper crankcase.
4) Remove the dowel pins.
Crankshaft / Conrod
1) Remove the crankshaft assembly (1) from the upper
crankcase.
2) Remove the thrust bearings (2).
NOTE
Remove the conrod if necessary. Refer to
“Conrod Removal and Installation (Page 1D-
90)”.
Transmission
Remove the transmission component. Refer to
“Transmission Removal in Section 5B (Page 5B-3)”.
Oil Jet
1) Remove the piston cooling oil jets (1) from the upper
crankcase.
2) Remove the oil jet (2) (for transmission oil spray)
from the upper crankcase.
I823H1140441-01
2
1
I823H1140442-01
I823H1140443-01
1
I823H1140444-02
2
I823H1140445-01