DISASSEMBLY AND ASSEMBLY 4-35
Push Rod
• Inspect the push rod for wear and damage.
• If any defects are found, replace the push rod with a new one.
Release Bearing
• Inspect the clutch release bearing 1 for any abnormality, par-
ticularly cracks, to decide whether it can be reused or should
be replaced.
• Smooth engagement and disengagement of the clutch
depends on the condition of this bearing.
• If any defects are found, replace the clutch release bearing
with a new one.
INSTALLATION
Install the clutch plates in the reverse order of removal. Pay
attention to the following points:
• Install the spring washer seat 1 and spring washer 2 onto
the clutch sleeve hub correctly.
To Next Page
Loading...
