4-36 DISASSEMBLY AND ASSEMBLY
• Apply engine oil to the drive plates 3 and driven plates 4.
• Install the clutch drive plates and driven plates one by one
into the clutch sleeve hub in the prescribed order as show in
illustration.
• Install the push rod and push piece 5.
• Apply engine oil to the release bearing 6.
• Assemble the release bearing 6 and washer 7 as shown.
• Fit the clutch pressure plate 8.
C Direction of outside
Color
A Driven No.1 plate Silver
B Driven No.2 plate Gray
C Direction of outside
To Next Page
Loading...
