DISASSEMBLY AND ASSEMBLY 4-83
• With the damper rod in fully extended position, pour the spec-
ified amount of fork oil.
Fork oil quantity (Inside the damper rod):
193 ml (6.5/6.8 US/lmp oz)
FORK OIL SS-19 or equivalent
• Apply fork oil to the O-ring 4.
NOTE:
Replace the O-ring 4 with a new one.
• With the damper rod held immovable in fully extended posi-
tion, gently install the compression damper unit 5 to the
sub-tank 6.
• Clamp the bottom (flat part) of the sub-tank with a vise.
NOTE:
Do not clamp the sub-tank too tight.
• Tighten the compression damper unit 5 to the specified
torque.
Compression damper unit: 30 N·m (3.0 kgf-m, 21.5 lbf-ft)
• With the damper rod held in vertical position, slowly move the
inner rod several strokes.
a 100 mm (3.9 in)
To Next Page
Loading...
