DISASSEMBLY AND ASSEMBLY 4-97
• Align the “ ” mark on the left grip with the matching mark B
on the left handlebar end.
• Align the matching mark C on the handlebars with the match-
ing surface clutch lever holder.
• Tighten the upper bolt D first temporarily to provide clearance
on the lower side and then tighten both the bolts 1.
• Install the engine stop switch 2 and clamps 3.
• Install the front number plate and handlebar pad.
INSPECTION AFTER INSTALLATION
• Front fork (2-39)
• Steering (2-41)
• Wiring harness, cable and hose routing
(5-10, -11, -20)
• Handlebars set-up (5-22)
To Next Page
Loading...
