4-10 DISASSEMBLY AND ASSEMBLY
• Install the muffler joint connector K and exhaust pipe gasket
L.
NOTE:
Replace the connector K and gasket L with new ones to pre-
vent exhaust gas leakage.
NOTE:
When installing a new connector K, clean the exhaust pipe and
joint of the muffler.
• Temporarily tighten the exhaust pipe nuts M.
• Insert the muffler to the exhaust pipe.
• Remove the grease and oil from the bolt and nut.
• Temporarily tighten the muffler mounting front bolt N and rear
bolt O.
To Next Page
Loading...
