Symmetricom TimeProvider 1000 Reference Guide

097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 143
Appendix B Alarms
Table B-1 provides a list of all alarm identifiers and a description of the alarm. The
AID type indicates if the event occurred in the unit (EQPT) or externally from an
input or output (T1). The table also shows if the alarm is service affecting (SA), or
non-service affecting (NSA)
Table B-2 is a list of alarm identifiers and conditional descriptions. The set and clear
alarm conditional description is the text that appears when the event occurs. In the
following example,
INPLOS is the Alarm ID and LOS FAULT is the set condition
description.
"INP1,T1:CR,INPLOS,NSA,05-01-17,15-10-03,,:\"LOS FAULT\""
Table B-1. Alarms
Alarm ID
or
CONDTYPE
Alarm Condition
Description
AID
Type
Service
Affecting
Error
Delay
Default
Error
Delay
Editable
Alarm Default
Level
SSU PRS SUB
<aid> = SYS
COMPAT System components (for
example IOC software
and hardware) are not
compatible.
EQPTNSA IMMEDNO MJMJMJ
EXTALM1 The external alarm used
to monitor alarms
generated by external
equipment.
EQPTNSA IMMEDNO MJMJMJ
EXTALM2 The external alarm used
to monitor alarms
generated by external
equipment.
EQPT NSA IMMED NO CR CR CR
PWRA The IMC has detected
the loss of power on the
A connection
EQPTNSA IMMEDNO MJMJMJ
PWRB The IMC has detected
the loss of power on the
B connection.
EQPT NSA IMMED NO MJ MJ MJ
IOC1EQPT
IOC1EQPT indicates that
the IOC was physically
inserted or removed from
the system.
EQPT NSA IMMED NO MJ MJ MJ

Symmetricom TimeProvider 1000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1000
Category	Clock
Language	English