Symmetricom TimeProvider 1000 Reference Guide

097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 157
Appendix C Events
This appendix lists all events and describes the possible cause. Table C-1 is a list of
events and descriptions and Table C-2 is a list of event code conditional
descriptions.
Table C-1. Event Identifiers
Event ID
or
CONDTYPE
Event Description
AID
TYPE
Default Value Value Description
IMC Event Codes
ACCLVL The user ‘s system
access level has
changed in the database
EQPT SECURITY –
when no users
have been
assigned to the
system
NONE – user has no access
USER – user can access user
level commands
ADMIN – user can access admin
level commands
SECURITY – user can access
security level commands
ACO Audio Alarm was
deactivated
EQPT NA NA
ALMCHG The IMC alarm
parameters have been
changed
EQPT NA Alarm Keywords and Values are
shown in Appendix B, Alarms.
When a Value is changed, the
ALMCHG event is generated and
the keyword and value is
displayed.
AOMERGE Enable/Disable
autonomous event
generation for the current
session.
EQPT ENABLE ENABLE – Enables the
autonomous messages to be
displayed in the current session.
DISABLE – Disables the
autonomous messages from being
displayed in the current session.
BAUD The IMC serial port baud
rate has changed
EQPT 9600 2400 | 9600 | 19200 | 38400 |
57600 | 115200
CMDCHG The command access
level was changed
EQPT ACCLVL=USER NONE | USER | ADMIN |
SECURITY
ECHO The communication
session’s echo setting
has changed
EQPT DISABLE
 ENABLE – User keystrokes
are echoed
 DISABLE – User keystrokes
are not echoed
FEATURE A System feature has
been enabled
EQPT NTP The NTP feature has been
enabled.

Symmetricom TimeProvider 1000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1000
Category	Clock
Language	English