SSSSSSSSSSS SSSS S SSSSS SSSSSSS S SSS S SSSSS S
4
110 TimeSource 3100
TL1 Reference
097-72020-01 Issue 9: November 2003
Conventions
Uppercase letters in a command designate parameter values which must be entered as
shown. Lowercase letters in a command are the parameter name, and the specific values that
must be entered for the parameter. The Parameters section of this chapter describes the
parameters and the values where a value is the same for all parameters. Parameter values for
a particular command are listed with the command. The system accepts either uppercase,
lowercase, or a mixture of both, but upper and lower case cannot be mixed within a
parameter block.
The following symbols are used in the input and response messages:
[ ] encloses an optional parameter
{ } encloses a group of parameters, at least one of which must be entered
| separates alternatives in a group of parameters, at least one of which must be
entered
^ indicates a space (used in the description of the response format, but not used in the
command responses)
_ separates command code fields
: separates parameter blocks
, separates parameters within a block
; terminates a command, and causes execution
" " encloses text to be parsed by a machine
/* */ encloses comments for humans encloses a TL1 named variable
\" "\ encloses a description of a condition
... indicates the previous line in a response may be repeated as required