3
TimeSource 3100 91
Installation
097-72020-01 Issue 9: November 2003
2
5
3
SSSSSSSSSSS SSSS S SSSSS SSSS SSS S SSS S SSSSS S
TimeWizard
The TimeWizard Software Installation application was created to facilitate installing
software upgrades for the TimeSource 3100. Procedure F shows how to install the
TimeWizard application and how to use TimeWizard to download software
upgrades.
Procedure F. TimeWizard Installation and Operation
Step Procedure
Use this procedure to install the firmware in the TimeSource 3100 to
configure the GPS and Holdover alarms, using the TimeWizard application.
Requirements:
1. A PC running Windows 95/98/NT 4.0/2000/XP.
2. The TimeSource 3100 CD labeled 992-72020-06 Rev. A, Version
1.06.04.
Hardware Installation
1 Connect the TimeSource 3100 to the PC with a serial cable.
Install the TimeWizard Software
2 Insert the TimeSource 3100 CD labeled 992-72020-06 Rev. A, Version
1.06.04 into the PC’s CD-ROM drive.
If AutoRun is enabled on the PC, the CD should automatically launch the
Install Shield wizard for installation of the TimeWizard application. If Install
Shield launches, continue with Step 5. If Install Shield does not
automatically launch, continue with the next step.
3 The Windows Explorer, double-click “setup.exe” in the root directory of the
CD to start the Install Shield wizard.
4 Follow the prompts in the Install Shield wizard to install TimeWizard in the
preferred directory.
Continue with the next step after the TimeWizard installation is complete.
To Next Page
Loading...
Need help?
General
