58 TimeSource 3100
Installation
097-72020-01 Issue 9: November 2003
SSSSSSSSSSS SSSS S SSSSS SSSS SSS S SSS S SSSSS S
3
Cabling
Warning: The circuitry on the plug-in circuit board is subject to electrostatic
discharge (ESD) damage. Be sure to wear an ESD wrist strap when making
connections to the connector panel. Failure to observe this warning may result in
equipment damage.
Warning: The faceplate on the card contains a plastic overlay bonded to the metal
plate with an adhesive. The overlay is an integral part of the ESD protection. Do not
pierce, peel, or otherwise violate the integrity of the overlay. Failure to observe this
warning may result in equipment damage.
The Craft connection is made at the shelf front panel. All other connections are made at the
shelf connector panel. To access the shelf connector panel, remove its cover.
Figure 13 shows the connectors on the front panel and connector panel. All connectors can
be located using these illustrations.
To Next Page
Loading...
Need help?
General
