4-165
4
SLEW MOTOR
DISASSEMBLY AND ASSEMBLY
8. Remove the cylinder block (18) and the disc (19).
9. Remove the shoe holder (20) and the piston assembly
(21) from the cylinder block.
10. Remove the guide (22) and pin (23) from the cylinder
block.
11.
Take out the snap ring (24), and remove the retainer
(25), springs (26) and retainer (27) from the cylinder
block.
WARNING
Components may pop out. Wear protective gear such
as goggles and a protective face mask.
• Remove the snap ring while pressing down the re-
tainer (25).
12.
Remove the swash plate (28).
13. Remove the shaft (29).
• Lightly tap the end face with a plastic hammer.
To Next Page
Loading...
