TDK-Lambda GH10-100 - Page 54

43
Function
Factory Reset
(Default Settings)
Reset
Last
Setting
Save & Recall
LAN parameters Default (Ref. LAN
Spec.)
- + -
Special Voltage Upper Limit (SVUL)
RATED
-
+
-
Special Current Upper Limit (SCUL)
RATED
-
+
-
Enable registers 00000 -
Depends on
*PSC
(SCPI
only)
-
Event registers
00000
00000
-
-
Power-On Status Clear
1
-
+
-
Display Brightness
3
-
+
-
Display Dim Delay [S]
30
-
+
-
Display Dim Brightness
2
-
+
-
Factory Calibration Parameters
Factory Calibration
-
-
-
Communication Watchdog (WD)
OFF
-
+
-
Communication Watchdog Timeout (WD.TIM)
[S]
1 - + -
Boolean commands return value
DIGIT
DIGIT
+
-
Table 2-6: Non-Volatile Memory Parameters
NOTES
*1 REM mode is set after AC recycle if LLO mode was set prior AC recycle.
*2 Refer to Table 1-4 , Reset Button, if Reset operation is performed by Reset Button located on
the rear panel. Refer to section 4.14.10, SYSTem:FRST <DSC> command, if Reset operation is
performed by communication interface.
Function
Factory Reset (Default Settings)
IP Address DHCP configuration
DHCP
Ping server
Enabled
Auto-Negotiation
Enabled
Description (Service Name)
TDK-LAMBDA Supply <last 3 serial number digits>
Password
Clear field (None)
Hostname
G[H]<rated voltage>-<rated current>
VXI-11 Discovery
Enabled
Keep-Alive Time [S]
1800
mDNS & DNS-SD
Enabled
Controller Access
One Client Only
Table 2-7: LAN Non-Volatile Memory Parameters