race-like situation.
Telemetry
Enables or disables the telemetry for the receiver.
When you should disable the telemetry:
● On a race. This frees the band for other pilotes.
● When you got black lines in your video feed. Make sure your cables are shielded or twisted to
avoid this issue in general
If you disable it, dynamic rf, dynamic power and the telemetry will no longer work. This means you
Crossfire Tx will send with the maximum set up power level and switch to 50Hz mode.
The LUA scripts are not affected by this. The Crossfire re-enables the telemetry for the time the datas are
sent and then turns it back off.
To Next Page
Loading...
