Emergency Update
If an OTA update for the receiver fails, it will no longer work. In this case you need to use the built-in
emergency update feature:
Standard Diversity Rx
The standard diversity receiver comes with an onboard usb connection. Therefore you can connect the
receiver with you TBS Agent X and update him straight away.
Micro/ Nano/ Nano Diversity Rx
Since FW 2.24 the Crossfire receivers stores a specific, “golden” firmware inside, which can be restored by
the following steps:
● Hold the bind button
● Power up the receiver
○ The led on the rx starts to flash rapidly
● Release the button
● Push and hold the button again
○ The led will start to blink in a double-patter
● As soon as the led switches to rapid flashing again, you can release the button
● When the pattern changes back to slow, single blinking the emergency update is finished
Now the receiver is working again and automatically turned on the bind mode. Now you can power up
your transmitter, start the binding and run the OTA update again
To Next Page
Loading...
