FAQ
Some common and some special outlier questions for the CROSSFIRE system.
● Droidplanner can’t connect to wireless close range telemetry module
○ Try to use DroidPlanner 2 only for MAVLink emulator not the Tower app
○ Go under settings and make sure connection type is set to Bluetooth
○ Go under Settings -> Advanced -> Connection Preferences and press forget default device
● TBS CROSSFIRE Seems not to work with Futaba T18SG
○ It required you use an external battery to power the TBS Crossfire
○ Go to Trainer port settings and select ACT, Student and 8 Ch. or 12 Ch.
● Does the transmitter forget the receiver when I bind a new receiver
○ No. The receiver stores the serial number of the transmitter. Everything is based on this.
So you can bind as many receivers as you want.
● What happens if I have more than one receiver running at time
○ We recommend to run only one receiver at time but if you like to, you can run more than
one receiver at time. As the system is not designed for this use case some features need to
be disabled to make it work properly. Make sure both receivers run in the same operation
mode, 8 or 12 channel mode and both have telemetry disabled.
Manual written and designed by ivc.no in cooperation with TBS, redesigned and maintained by
kamikatze-fpv.de
To Previous Page
