WiFi telemetry with BetaFlight/ INav
For the WiFi telemetry, you need to wire up your FC with a extra MAVLink connection, as the MAVLink
emulation is not (yet) supported by the WiFi firmware:
Settings in BetaFlight/ INav
On the port where you got your extra MAVLink connection installed, enable MAVLink with 57600Baud in
the
PORTS
tab for that UART.
Note: You need to cancel the “loading parameter” dialog in MissionPlanner etc, as it will not get past this
dialog. The important telemetry data will be sent anyway.
To Next Page
Loading...
