Attention
These Long Range Systems are capable of radio frequency transmissions and output power that may be
not allowed in your country.
Please always check your local RF legislation to set the frequency and output power according to
the regulation.
A general rule for RC aircrafts is that they must be controlled always under sight of view, check your RC
regulation to keep up to date with regulations.
Getting ready
Getting set up and ready to fly is a quick and simple task. In most cases plug&play when using TBS
equipment.
FAQ
If you got any question after reading this manual you should visit the TBS FAQ section
Note
This manual is written based on
Crossfire FW 4.00
. If some functions are not available for you, please
update your Crossfire to this (Beta) or a later version.
Updating
In order to update and configure your Crossfire, you need the TBS Agent X, which you can download from
the TBS shop.
To update your Crossfire, connect it by the USB-port of the transmitter and run the update by Agent X.
The receiver will then get the update while the next binding (details can be found in the receiver update
section)
For detailed instructions on how to use the Agent X, have a look at the Agent X manual.
To Next Page
Loading...
