MultiLevel Instruction Manual Other Information
Key:
Date: Date of approval
LRP: Legally relevant part
NRP: Legally not relevant part
CC: Country Code
Date LRP NRP CC Comment
18.08.08 1.21 [1.21] DE Temperature-volume conversion for ethanol/petrol mixtures added
Erroneous behavior after printing an emergency receipt corrected
Calculation of the parameter checksum corrected
Error handling for internal level sensor errors changed
Warning messages added to the program section ‘Level sensor calibration’
Warning messages added to the program section ‘Inclination sensor calibration’
Print screen function implemented in various program sections
Data transmission to the calibration unit
10.04.08 1.20 [1.20] DE
Conditions for exiting delivery mode adapted
Time delays for the wet leg sensor taken into account
Uncoupling of the hose taken into account in the sequence
Optimization of communication & speed
Access to the memory card improved
Revision of the evaluation and handling of errors
Expansion of the memory capacity
Line & page counter for printout corrected
User guidance for the printout of logbooks standardized
Data transmission from/to the chip card optimized
Factory setting for ‘Float MAX’ parameter changed
Additional logbook entries for various events
Logbook entries in the case of changes of valve states only on changes
Print screen function when displaying messages
Printer reservation corrected
Second language implemented
Print screen error corrected
Missing parameters added to the printed parameter list
17.08.07 1.16 [1.16] DE
Seal breakage on change of the software checksum
User guidance for logbook printout adapted
Direct exit from loading mode only by pressing the STOP button
Change of valve states now recorded correctly in the logbook
Synchronization of the operating mode between MultiLevel and NOMIX changed
08.06.07 1.15 [1.15] DE
Initialization when restoring factory settings improved
Querying / evaluation of printer status and printer controller improved
Time delay inserted for detection of residual volume
Communication with the level sensors improved
Preparation for preset control
Event logbook extended & supplemented
Menu system updated
30.01.07 1.10 [1.10] DE
Change of date only possible with broken seal
Switch-on delay for error evaluation
Logbook entries in the case of unmeasured / uncalibrated delivery
New menu entry: ‘Print seal’
Optimization of the checksum calculation
Gauge tables only exported if the data is correct
NOMIX status display removed
Editor for YES/NO queries can be exited with <STOP>
Calculation of the compartment volume corrected
Layout of the delivery receipt adapted
18.08.06 1.00 [1.00] DE
To Next Page
Loading...
Need help?
General
