๎ณ๎๎๎๎๎๎๎๎๎๎ฐ๎ฑ๎ฉ๎๎๎๎๎๎จ๎ฑ๎๎๎๎ง๎ฒ๎ฎ๎๎๎๎๎๎จ๎๎๎๎ฌ๎๎๎๎๎๎ต๎๎๎๎๎๎๎๎๎๎๎๎๎๎
9.7.1.4.2.1.2. Preset Type โ 314212
๏
Possible settings:
"Preset to V0" / "Preset to VT"
In the case of โPreset to V0โ (factory
setting), the volume is preset to the
compensated volume (V0).
In the case of โPreset to VTโ, the volume
is preset to the uncompensated volume
(VT).
9.7.1.4.2.1.3. Preset Type โ 314213
๏
Possible settings:
YES / NO.
If set to <YES> (factory setting), an
automatic adjustment of the correction
value (parameter 313xx51) for the volume
presetting takes place after each delivery.
This correction value is necessary
because, after the command is given
to close the valves, a certain amount of
๎๎๎๎๎๎๎๎๎๎๎๎๎
๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎
stopped. This after run quantity can be
entered in the correction value, so that
๎๎๎๎๎๎๎๎๎๎ฟ๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎
๎๎๎๎๎๎๎๎๎๎๎ฟ๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎๎
If set to <NO>, no automatic adjustment of the correction value takes place.
9.7.1.4.3. Filling โ 3143
Explanation of the submenus
1 Valve Control
2 Loadplan Query
3 Loading Measurement
MultiLevel Instruction Manual MENU structure
To Next Page
Loading...
Need help?
General
