MultiLevel Instruction Manual MENU structure
Previous behavior:
• The foot valves of filled compartments cannot be opened
New behavior:
• With a sealed device, the behavior is as before.
• If the device is not sealed and the DIP switch 8 = ON: Foot valves can always be switched.
9.8.4. Initialization – 44
The factory settings can be restored in this menu in the event of serious errors.
Prior to initialization, always sve the set parameters on a chip card to enable
these to be re-loaded at a later date (chapter 9.8.5 "Chip card - 45").
CAUTION:
As a safety precaution, the parameters must always be printed out before every
initialization process.
Initialization screen
Then the following screen appears:
Press the <F1> = OK key to restore
the factory setting or
press the <F3> = BACK key to terminate
the process.
9.8.5. Chip Card – 45
The setup parameters and the gauge tables can be read from or written to the chip card in
this menu.
Chip card screen
Explanation of the submenus
1 Read param.
2 Write param.
3 Read gauge tab.
4 Write gauge tab.
5
6
7 Read Layout
8 Write Layout
To Next Page
Loading...
Need help?
General
