STEPRACE: Service & Maintenance Manual - rev. 1.2
Page 5.2
5.3. FIRST POWER-ON
After completing the installation procedure, the machine is ready to be powered up. To turn on the
machine, simply toggle the on/off switch from the 0 position to the 1 position.
When the machine is turned on it will perform a power-on test which:
• sounds the buzzer;
• lights all the LEDs.
At the end of the power-on test the machine enters standby mode, awaiting a keyboard command.
To check the correct operation of the machine:
• start exercising;
• check that the SPM value displayed varies accordingly;
• check that the effort level varies when the “+” and “−” keys are pressed, and that the
corresponding difficulty level LEDs come on and off;
• change the position of the selection knob and check that the SW recognizes the selected
stepping mode;
• put on the heart rate transmitter and check that the machine correctly measures the heart rate
value.
To Next Page
Loading...
