STEPRACE: Service & Maintenance Manual - rev. 1.2
Page 7.18
7.14. DISASSEMBLING THE LEVERS
Figure 7.14-1
Carry out the procedures described in paragraphs
7.8. “Disassembling the side guards”, 7.11.
“Disassembling the pedal joint” up until step 3.,
7.12. “Disassembling the pedals and pedal
group” and 7.13. “Disassembling the pedal
connecting rods”.
1. Select training mode B (dependent stepping
motion).
On both sides of the machine:
2. Back off the screw a using a 17-mm wrench.
3. Remove the LEVER and its bearings using
the appropriate extractor tool.
To reassemble the LEVERS, carry out the above
steps in reverse order.
To Next Page
Loading...
