Tektronix CSA7404B - Page 10

Table of Contents
vi
CSA7404B, TDS7704B, TDS7404B, TDS7254B & TDS7154B Service Manual
Figure 4--29: Initial test hookup 4--107..............................
Figure 4--30: Measurement of trigger out limits 4--109.................
Figure 4--31: Initial test hookup 4--110..............................
Figure 4--32: Measurement of probe compensator frequency 4--111......
Figure 4--33: Subsequent test hookup 4-- 112.........................
Figure 4--34: Measurement of probe compensator amplitude 4--113......
Figure 4--35: Initial test hookup 4--114..............................
Figure 4--36: Isolated 0 triggering 4--116............................
Figure 4--37: Isolated 1 triggering 4--118............................
Figure 4--38: N modulo 3 triggering 4--120...........................
Figure 4--39: Initial test hookup 4--121..............................
Figure 4--40: Clock recovery 4--124.................................
Figure 4--41: Initial test hookup 4--125..............................
Figure 4--42: Initial test hookup 4--127..............................
Figure 4--43: Initial test hookup 4--129..............................
Figure 4--44: Optical bandwidth hookup 4--134......................
Figure 4--45: Proper positioning of the impulse 4--135.................
Figure 4--46: Optical impulse response 4--136........................
Figure 4--47: Equipment setup for maximum amplitude 4--138.........
Figure 6--1: Line fuse and line cord removal 6--12...................
Figure 6--2: Knob removal 6--13..................................
Figure 6--3: Trim removal 6--15...................................
Figure 6--4: Bottom cover removal 6--16............................
Figure 6--5: Cover removal 6--18..................................
Figure 6--6: Cover removal 6--19..................................
Figure 6--7: External modules 6--20................................
Figure 6--8: Internal modules 6-- 21................................
Figure 6--9: Front-panel assembly removal 6--24.....................
Figure 6--10: J1 flex cable connector removal 6--25...................
Figure 6--11: Front panel board and keyboard removal 6--26..........
Figure 6--12: Display removal 6--28................................
Figure 6--13: Touch panel and LCD assembly removal 6--29...........
Figure 6--14: Display adaptor board removal 6--30...................
Figure 6--15: Power flex circuit removal 6--31.......................
Figure 6--16: Floppy disk drive assembly removal 6--32...............
Figure 6--17: Floppy disk drive removal 6--33.......................
Figure 6--18: Hard disk drive removal 6--34.........................
Figure 6--19: Separating the halves of the drive cartridge 6--34.........
Figure 6--20: Hard disk drive removal from cartridge 6--35............