Removal and Installation Procedures
6-46
CSA7404B, TDS7704B, TDS7404B, TDS7254B & TDS7154B Service Manual
4. Remove the Micro ATX Board: See Figure 6--31, page 6--47.
a. Disconnect the J9G1 USB, J9F2 Front Panel USB, J2H1 power, J6H1
and J6H2 IDE, and 12 V cable connectors from the Micro ATX board.
J6H1 IDE
J2H1
power
12V
J9F2 front
panel USB
J6H2 IDE
J9G1 USB
Figure 6- 30: Cables
b. Remove the six T-15 Torxdrive screws that secure Micro ATX board to
the ATX assembly.
c. Remove the 3/16 nut posts that secure the connectors to the rear of the
ATX assembly.
d. Remove the Micro ATX board from the assembly.
5. Reinstallation: Do in reverse steps 3 and 4 to reinstall the Micro ATX board.
To Next Page
Loading...
